JESWO Tri-band WiFi 6E Gigabit Network Card Drivers Installation

Thank you for purchasing the JESWO Tri-band WiFi 6E Gigabit Network Card (PCIE-08), please follow the below instruction for driver installation: 

1. Hardware Installation

1-1. Insert the wireless adapter into the PCl-Ex1 slot (Also compatible with PCI-Ex4,PCI-Ex8,PCI-Ex16 slots) and
screw the bezel.

NOTE: Please shut off the computer's power before installing the hardware.

1-2.  Plug the Bluetooth cable into the wireless adapter and the motherboard interface.

1- 3. Install the antenna. 

2. Wireless Adapter WiFi Driver Installation

2-1. Download the driver here: 

PCIE-08 Driver for Windows OS

Note: As the installation file is a compressed package, you must decompress it before installing. 

2-2. Installation:

This installation method uses the win10 system as an example, open the corresponding driver folder, double-click “AXPClE WIN WiFi setup.exe" to run the installation program, and the installation will be completed automatically. 

2-3. Connect the PCl-e adapter to Wi-Fi
2-3-1. 0pen the internet icons  at the lower right corner of the computer.

2-3-2. Search and connect the Wi-Fi you prefer on the detected Wi-Fi list, and then enter the Wi-Fi password to connect.

03, Finally you are connected to the Wi-Fi.

3. Bluetooth Driver Installation

3-1.  Unzip the downloaded driver, and double-click “AXPCIE WIN BT setup.exe”,  and click "Next" until the driver is installed.

3-2.  Connect the Bluetooth devices with the adapter: 

 

Note:
1. Only support for win10(64 bit)/win11(64 bit).
2. After the installation is complete, restart the computer.